MFM Peel & Seal is the original, patented self-stick roll roofing. Peel & Seal roll roofing is ideal for roofs and surfaces that are difficult to waterproof and can be used on many surfaces including: metal roofs, mobile homes, RVs or trailers, and sunroofs. MFM Peel & Seal can also be used as flashing around ducts, vents, chimneys, air conditioning units, or even on gutters.
MFM Peel & Seal is made of aluminum composite foil, polymer films, and a rubberized asphalt adhesive back, making it flexible and self-adhering. Peel & Seal roll roofing will not tear, crack or dry out over time. It is designed specifically to reflect heat and resist water and exposure to other elements without any additional coverage needed.
This self-adhering rolled roofing is very simple to install. Simply make sure your surface is clean, smooth, dry and free of any loose debris. Be sure to prime your surface with an asphalt primer before applying Peel & Seal, especially on surfaces made of plywood, OSB, composition board, and masonry. After the roof is prepped, you will simply peel off the release paper on the back of your peel and seal, and roll it out onto your surface, using a hand roller to smooth out any creases. Finally, use a sharp knife to cut off the desired length.
- Sticks to almost any surface
- Can be used on RVs and Trailer homes
- Secure and waterproof seal
- No special tools needed
- 4 colors available
- Up to 6 different widths available
- 36in. Wide Rolls have 3in. lines on each side
- High wind tolerance
- Made in the U.S.A.
- CLICK HERE FOR FREE SAMPLES
- Thickness: 45 mills
- Colors Available: Almond, Aluminum, Gray, White
- Length of Each Roll: 33ft. 6in.
- Widths Available:
- 4in. (9 Rolls per Case)
- 6in. (6 Rolls per Case)
- 9in. (4 Rolls per Case)
- 12in. (3 Rolls per Case)
- 18in. (2 Rolls per Case)
- 36in. (1 Roll per Case)
Building Code Approvals
Also Tested to Meet ASTM D 1970 Requirements
Simply click on any image to see it full size and click it again to close it